3 requirements for Case erector

09 Jun.2023

The case erector uses a lot of automatic packaging equipment in the automated production line, which is combined with the carton to form an automated packaging line. However, due to the non-adaptive nature of case erector, the carton applicable to case erecto is required to meet certain needs. Yupack will introduce 3 specific requirements below.

1. Cut the corners of the carton. This place is the easiest to distinguish between the manual box and the machine box, the manual box generally does not have this cutting process, and the machine box must have this process, otherwise erector cannot open the box normally.

2, carton crease. The crease of the carton directly affects whether the case erecto can fold up the cover of the carton, and the general requirement in the general industry is that the depth of the crease should reach at least one-third of the thickness of the carton.

3, the correct degree of carton bonding. After folding, the top cover of the carton often fails to match it well, and there will be a long side and a short side, which is the reason for the poor accuracy of the carton when gluing. Therefore, the carton will be very ugly after unpacking.

The above is the 3 requirements of the carton unpacking machine summarized by Yupack for you. In the future articles, Yupack will also share other requirements of case erecto on the carton with you. Welcome your continuous attention!